What should I pay attention to when using inline LED beads?P3 soft LED module

　　1、 Direct insertion LED lamp bead cleaning

　　When cleaning colloids with chemicals, special care must be taken, as some chemicals can damage the surface of the colloids and cause discoloration, such as trichloroethylene, acetone, etc. Ethanol can be used for scrubbing and soaking, and it should be kept at room temperature for no more than 3 minutes at all times.

　　2、 Pay attention when bending and cutting the legs of LED lamp beads inserted directly

　　Due to design requirements for bending and cutting feet, when stopping bending and cutting feet on LED, the position of the bending and cutting feet should be greater than 3mm from the bottom of the gel. Bending should be done in the welding line. When using LED lamp insertion, the distance between the PCB board hole and the LED pin should correspond. During foot cutting, high voltage static electricity occurs due to vibration and friction of the foot cutting machine. Therefore, the machine should be reliably grounded and anti-static operations should be carried out.

　　3、 Forming Method of Direct Insertion LED Bead Pins

　　1. It is necessary to be 2mm away from the gel before bending the bracket.

　　2. The forming of the bracket must be completed before welding.

　　3. The forming of the bracket needs to ensure that the pins and distance are different from those on the circuit board.

Read recommendations:

outdoor led screen modules manufacturer

FC series outdoor common cathode energy-saving full-color LED display

P6 outdoor LED module

LED font

LED application development.full color outdoor led screen Processing