LED light belt installation method.outdoor rental led screen wholesaler

　　① The four -line lamp bandwidth is about 22mm, the thickness is about 8mm, and the weight is about 0.25kg/m (4 meters per kilogram)

　　② There are four wires in the four -line lamp band, three rows of lights (note that it is not four rows of lights ~~), 1 meter 24 lights per row, 24*3 = 72. Because the power of each lamp is 0.05W, the power of the 72 beads is: 72*0.05 = 3.6W.

　　③ There is a "scissors" mark per meter. It can only be remembered by the tags, and the wrong or cut will cause one meter to not be bright! Some will be partial because of the mark. Position, cut it according to the place where there is no connection in the middle. You can see it carefully.

　　④ Each lamp belt must be equipped with a dedicated plug (plug with a transformer); when connecting, you must remove the transparent plastic cover, connect the test light and then cover it. Do not directly connect to the lid, so it is easy to be short -circuited.

　　⑤ When the light belt is installed, it is generally placed in the lamp groove, and it can be straightened. You can also fix it with a thin rope or thin iron wire. If you need an outer or vertical installation, you need to buy another card and tail. The original card is fully transparent. It is best to use waterproof glass glue at the tail and plug after installation, so that the waterproof performance is better.

Read recommendations:

led display panel module Manufacturing

Small Pixel P1.56

Staduim LED display

IP65 High Brightness led modules.SMD LED

LED chip classification