Introduction to the scanning mode of LED display

source:Industry Trends release time:2022-11-11 Hits:     Popular:led screen wholesaler

Share:

  Small Pixel P1.56

  1、 Classification of scanning modes of LED display:

  Scanning mode: the ratio of the number of lines lit at the same time to the number of lines in the whole area within a certain display area.

  1. Static scanning: Static scanning is a "point-to-point" control from the output of the driver IC to the pixel. Static scanning does not require a control circuit, and its cost is higher than dynamic scanning, but it has the advantages of good display effect, good stability, and small brightness loss.

  2. Dynamic scanning: Dynamic scanning is a "point to column" control from the output of the driver IC to the pixel points. Dynamic scanning requires a control circuit, which costs less than static scanning. However, the display effect is poor and the brightness loss is large.

  2、 By environment:

  Indoor single and dual color scanning is generally 1/16 scanning, indoor full color scanning is generally 1/8 scanning, outdoor single and dual color scanning is generally 1/4 scanning, and outdoor full color scanning is generally static scanning.

  3、 Differentiation by model:

  1. The scanning mode of indoor full-color LED display screen: P4 and P5 are constant current 1/16, and P6 and P7.62 are constant current 1/8.

  2. The scanning mode of outdoor full-color LED display screen: P10 and P12 are constant current 1/2 and 1/4, and P16, P20 and P25 are static.

  3. The scanning mode of single and dual color LED display screen mainly includes constant current 1/4, constant current 1/8 scanning, and constant current 1/16 scanning.

  4、 LED display 1/4 and 1/8 scanning modes:

  1/4 scan: under the same other conditions, the 1/4 scan display screen has only half the brightness of the 1/2 scan display screen, which is suitable for semi outdoor and indoor use. Its control mode is from 1/2 of two LEDs to four LEDs. The current is scanned between 4 LEDs.

  1/8 scan, 1/16 scan: these are lower brightness driving methods, and are generally only used indoors. Their control mode is also deduced from this.


Read recommendations:

outdoor led screen wholesale

p8 outdoor LED module

P5 indoor LED Display

Outdoor electronic screen advertising.indoor led display screen Manufacturing

p2.5 outdoor LED module.LED dimming system

LAST: The hot trend of LED display industry to promote channel sinking NEXT:Differences between in-line LED display and surface mounted LED display
RETURN

Recommended News