Tips for LED display maintenance

source:other news release time:2022-11-14 Hits:     Popular:led screen wholesaler

Share:

  P4.81 outdoor LED display

  1、 Local "dead light" problem

  Local "dead light" means that one or several lights on the light surface of the LED display screen do not light up, which can be divided into full time and part of the color. Generally, this is because the light itself has a problem, or it is affected by moisture, or the RGB chip is damaged. Our maintenance method is very simple, that is, we can replace it with the spare LED lamp beads provided by the factory. Then the tools used are tweezers and hot-air guns. After replacing the spare LED lamp beads, Use the test card to retest. If there is no problem, it has been repaired.

  2、 The "caterpillar" problem

  The term "caterpillar" is just a metaphor, which refers to the phenomenon that when the LED display screen is powered on without an input source, a long dark and bright strip appears on some lamp surfaces, mostly in red. The root cause of this phenomenon is the leakage of the internal chip of the lamp, or the short circuit of the circuit of the IC side tube behind the lamp. The former is the majority. In this case, we only need to take the hot air gun to blow the hot air along the discolored "caterpillar" that is leaking electricity. When the problem lamp is blown, it is generally OK. Because the internal leakage chip connection is opened due to heat, but there is still a hidden danger. We just need to find the LED lamp bead that is leaking electricity, and replace the hidden danger lamp bead according to the method mentioned above. If the line on the back IC side is short circuited, you need to use a multimeter to measure the relevant IC pin circuit and replace it with a new IC.

  3、 Local color block missing

  Friends who know about LED display screen must have seen this problem. It is that a small square heterochromatic block appears when the LED display screen plays normally. This problem is usually caused by the burning of the color IC behind the color block. The solution is to replace it with a new IC.


Read recommendations:

rental led display manufacturer

P3 outdoor LED display

P2.5 indoor LED module

How to choose LCD splicing screen stitching

LED dot matrix display driver scheme.P2.5 soft LED module

LAST: How to realize seamless splicing of LED display NEXT:A complete list of accessories for an LED display
RETURN

Recommended News