led flash how to repair.problem of control pixels of full-color LED display

source:Industry Trends release time:2024-04-03 Hits:     Popular:led screen wholesaler

Share:

  

  First, power supply problems

  1. Check whether the power socket is firmly inserted. If it is firmly plugged in, unplug the power supply and wait a few minutes to try again.

  2. Check whether the power cord is damaged or in poor contact. Pull out the power cord and check whether the wire is obviously worn or damaged. If yes, replace the power cord with a new one.

  3. Check whether the power adapter works properly. You can use a multimeter to measure the output voltage and current of the adapter. If it is not within the standard range, you need to replace it with a new adapter.

  Two, wiring problems

  1. Check whether the wiring between the bulb and the power cord is firm. Open the lampshade, check whether the connector between the bulb and the power cord is loose, if loose, reinsert and fix;

  2. Check whether the power cord is well connected to the bulb base. Tighten the screws at the joints to ensure good contact.


Read recommendations:

P2.5 outdoor/indoor led screen module

P3.91 indoor LED display

p8 outdoor LED module

P2 soft LED module.How to adjust the brightness of indoor full-color LED display?

LED DC control.P6.67 oudtoor LED display

LAST: LED car display.p4.81 led screen NEXT:LED stage rental screen.shenzhen led screen display module
RETURN

Recommended News