Some issues that need to be paid attention to during the use of inline LED lamp beads.P3 outdoor LED module

　　1. Welding premise: (The welding point must be at least 2mm away from the resin root) Immersion welding: Please complete the welding once within 5 seconds at 260 ℃, and also avoid resin immersion in the tin bath.

　　Soldering iron: Use a 30W soldering iron with a tip temperature not higher than 350 ℃, and complete the welding once within 5 seconds.

　　Do not apply external force to the product during welding. Pay attention to avoiding erosion or discoloration of LED pins, as it may cause welding difficulties. It is recommended to use them in real time as soon as possible.

　　2. Precautions for use:

　　Pin forming must be completed before welding, and the spacing between device holes on the circuit board should be consistent with the electrode pins.

　　Pin cutting of the product under high temperature conditions may cause defects. Please perform pin cutting at room temperature. Before the welding temperature returns to normal, it is necessary to avoid causing any disturbance or external force on the LED.

　　3. Electrostatic protection:

　　High brightness blue, green, and white products are sensitive to static electricity. When using them, it is necessary to pay attention to the possibility that static electricity surges can damage or damage the product. For mission platforms in contact with the product, please use conductive pads to ground through resistors; The tip of the soldering iron must be grounded; Recommend using an ion generator.

Read recommendations:

led display panel module

p2.5 outdoor LED module

p8 outdoor LED module

p6.25 outdoor led screen.How to do a good job in daily maintenance of transparent LED display screen

How to choose LED display screen for large stage